INSTALLATION

Peel and stick wallpaper
Hanging instructions

STEP 1: SURFACE PREPARATION
To ensure your wallpaper adhesive sticks to the surface,
make sure it is completely smooth, clean, and dry. Walls
must be smooth before installation. Any type of wall texture,
including orange peel texture, will not allow your wallpaper
to adhere properly. Give your surface a brief wipe down with
a clean, dry cloth

STEP 2: PLANNING YOUR LAYOUT
Please lay out all panels before beginning your installation.
Revisit our website if you need a reference photo of your
design. Mark your wall for positioning of Panel 1. For ease of
installation, leave a 2" bleed of excess on the left side. To
ensure straightness of your mural, use a level to mark the
end of Panel 1.

STEP 3: INSTALL FIRST PANEL
Peel back 5" of the lining and trim. Leave a slight 2" bleed
overhang at the top of the first panel to begin installation.
This will avoid any gapping due to slanting and uneven walls
and ceilings.
Use a plastic scraper or squeegee to smooth out the panel
onto the wall.
Remove the lining as you go.

If bubbling begins to occur once the panel is installed, poke
the bubble with a needle or exacto knife and smooth it out
with your scraper or squeegee.

STEP 4: INSTALL SECOND PANEL
Approximately 1" of the second panel will overlap the first
panel.
Most importantly, the overlap will help you line up the design
easily.
Peel back the lining at the top and remove as you work your
way down.
Squeegeeing and smoothing as you go. Continue for the
rest of the panels and trim the excess wallpaper once
finished.

**OPTIONAL STEP 5: CUTTING THE SEAM
If the seams between the panels are noticeable, take a
straight edge ruler and an exacto knife to slice through the
middle of the overlapping two layers of mural. Gently peel
away the outer piece of excess material. Peel away the
remaining excess material underneath the overlap. Smooth
the panels back together and you should now have perfectly
matched seams!